A division of Toptech Group
+234 909 461 7398

ELECTA UPS ONLINE

Product Info

Model: Client ELECTA UPS ONLINE
Range: Skills 10 kVA - 20 kVA

Product Description

Installation flexibility
EM/ET 10,15,20 is available in two different cabinet frames:
• 1320mm high housing: batteries to for back up time up to
30 minutes on 20 kVA or Isolation transformer;
The single phase output (EM 10, 15, 20 kVA) thanks to Its
highly flexible design allows full compatibility with both threephase
and single-phase power supplies, thus eliminating
problems in connecting the UPS to the system.
Battery care system
Proper battery care is critical to ensuring correct UPS
operation in emergency conditions. The Lever UPS battery
care system consists of a series of features and capabilities
to optimise battery management and obtain the best
performance and operating life possible. Battery recharging:
Electa is suitable for use with hermetically sealed leadacid
(VRLA), AGM and GEL batteries and Open Vent and
Nickel Cadmium batteries. Depending on the battery type,
different charging methods are available:
• One-level voltage recharge, typically used for widely
available VRLA AGM batteries
• Two-level voltage recharge according to IU specification
• Charge blocking system to reduce electrolyte consumption
and lengthen the life of VRLA batteries.
Recharge voltage compensation based on temperature in
order to prevent excessive battery charges or overheating.
Battery tests to diagnose in advance any reduction in
performance or problems with the batteries. Deep discharge
protection: during extended low-load discharges, the endof-
discharge voltage is increased – as recommended by
battery manufacturers – to prevent damage or reduced
battery performance. Ripple current: recharge ripple current
(residual AC component) is one of the main causes of
reduced reliability and battery life. Using a high frequency
battery charger, Electa reduces this value to negligible levels,
prolonging battery life and maintaining high performance
over a long period of time. Wide voltage range: the rectifier
is designed to operate within a wide input voltage range
(up to – 40% at half load), reducing the need for battery
discharge and thus helping to extend battery life.

The Electa series is ideal for protecting data centres and
telecommunications systems, IT networks and critical
systems in general, where the risks connected with poor
energy supply can compromise the continuity of activities
and services. The Electa series is available in 10-15-20 kVA
models with threephase/ single-phase input and singlephase
output, and 10-15-20 kVA models with three-phase
input and output and on-line double conversion technology
in accordance with VFI-SS-111 classification (as set out in
standard IEC EN 62040-3). Electa is designed and built using
state-of-the-art technology and components. It is controlled
by a DSP (Digital Signal Processor) microprocessor, to
provide maximum protection to the powered loads with
no impact on downstream systems, and optimised energy
savings.

Leave a Reply

INDELEC Distributors in Nigeria| INDELEC representative in Nigeria | GTEC UPS in Nigeria | MAKELSAN AVR Distributor in Nigeria | LEVER inverter in nigeria -

INDELEC Distributors in Nigeria| INDELEC representative in Nigeria | GTEC UPS in Nigeria | MAKELSAN AVR Distributor in Nigeria | LEVER inverter in nigeria –